The Ford Barn - View Single Post

john charlton · 07-31-2021, 12:53 PM

I would drill out the rivets if they have sheared flush they might just punch out . Get suitable bolts chuck them in a variable speed drill and using a angle grinder with a flapper disc fashion look alike rivet heads . When they are inserted they look original and nobody can see the nuts and lock washers under the trim on the inside . I put my trusty Bosch drill in a padded vise and dress the bolt head with the flapper disc works a treat and wear eye protection of course .If the failed tack weld is preventing the bracket from seating fully home you must remove it but for sure you know this , just sayin !!!

John in rain showers Suffolk County England .

07-31-2021, 12:53 PM	#2
john charlton Senior Member Join Date: May 2010 Posts: 1,304	Re: Phaeton body rivets? I would drill out the rivets if they have sheared flush they might just punch out . Get suitable bolts chuck them in a variable speed drill and using a angle grinder with a flapper disc fashion look alike rivet heads . When they are inserted they look original and nobody can see the nuts and lock washers under the trim on the inside . I put my trusty Bosch drill in a padded vise and dress the bolt head with the flapper disc works a treat and wear eye protection of course .If the failed tack weld is preventing the bracket from seating fully home you must remove it but for sure you know this , just sayin !!! John in rain showers Suffolk County England .