[Trelpdx]

Guys,


I'm rebuilding my Dads 41 flathead. The distributer is the 37-41 style with the 37-41 caps and rubber boots. I must be missing the metal tubes that run from the rubber boots up along the heads where the plug wires come out. I had an old set off my 35 Ford and they don't even come close to fitting the 41 as the heads are configured differently. Are there plug wire tubes for just 37-41 engines? I was also considering running without the metal tubes but I was afraid of water getting into the distributer without them.


Need help.


Thanks much, Peder