The Ford Barn - View Single Post

Jim Brierley · 01-10-2015, 09:15 PM

Sponsored Links (Register now to hide all advertisements)

If you are concerned, enlarge the holes. I do that on the intake and outlet sides. Best done in a mill. I also turn the shaft down between the bearing surfaces to .375".

01-10-2015, 09:15 PM	#5
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,091	Re: Oil pump Sponsored Links (Register now to hide all advertisements) If you are concerned, enlarge the holes. I do that on the intake and outlet sides. Best done in a mill. I also turn the shaft down between the bearing surfaces to .375".