The Ford Barn - View Single Post

Tom Wesenberg · 02-03-2017, 02:46 PM

On the oil well on the right side, at the seam of the block and cap, does the bottom edge (cap edge) have a nice radius to allow the oil to get rolled into the clearance?
A sharp edge would be more likely to scrape away the oil.

02-03-2017, 02:46 PM	#45
Tom Wesenberg Senior Member Join Date: May 2010 Location: Mpls, MN Posts: 27,582	Re: Insert bearings On the oil well on the right side, at the seam of the block and cap, does the bottom edge (cap edge) have a nice radius to allow the oil to get rolled into the clearance? A sharp edge would be more likely to scrape away the oil.