[Tinbasher]

Welcome Aboard. Your in the right place for info. A couple of things to check. Make sure the wheel fits the spine or shaft properly. If it's new steering wheel it could be under size. Also check and see if the key is the right size. The slots in the new wheels can be to small as well. If that is all good then you can slip a deep socket over the steering wheel body and give it a couple of taps to seat the wheel on the shaft and see where you are. The nut usually just comes flush with the shaft. Also if your using a new Horn rod they can be the wrong size as well. Sometimes to long, sometimes to short. Also check and make sure that the clip at the bottom fits the shaft properly and the clip will fit inside the two finger actuator at the bottom as well. You can tell I love aftermarket parts.