The Ford Barn - View Single Post

Russ/40 · 04-17-2021, 12:15 PM

Very well documented Tail Dragger ! This is a good heads up for everyone. I'm sometime away from putting mine together, and knowing about the caps that won't be missed for sure. I'll check my Clevite bearings for the variability you observed. Terry, kudos for managing the situation professionally. I'm wondering about the platigauge results though. Especially main 5.

04-17-2021, 12:15 PM	#58
Russ/40 Senior Member Join Date: May 2010 Location: Santee, California Posts: 3,505	Re: The new Burtz Mosel A engine Very well documented Tail Dragger ! This is a good heads up for everyone. I'm sometime away from putting mine together, and knowing about the caps that won't be missed for sure. I'll check my Clevite bearings for the variability you observed. Terry, kudos for managing the situation professionally. I'm wondering about the platigauge results though. Especially main 5.