View Single Post
Old 09-27-2020, 05:03 PM   #4
Russ/40
Senior Member
 
Russ/40's Avatar
 
Join Date: May 2010
Location: Santee, California
Posts: 3,505
Default Re: Question on Cam Gear Marks - UPDATE

There was no TDC mark except the one I created with heads off and a dial indicator. This is a 41 block with the factory correct pulley and crank mounted fan. I did use an 8BA crank.

Terry, would that cause so much advance? I can check it. I even used a different distributor this time. There was too much advance on the other distributor before. I'll have to look up which set is responsible for timeing as well as dwell.

Last edited by Russ/40; 09-27-2020 at 05:10 PM.
Russ/40 is offline   Reply With Quote