View Single Post
Old 08-21-2020, 06:41 PM   #13
California Charlie
Senior Member
 
California Charlie's Avatar
 
Join Date: May 2010
Posts: 157
Default Re: Frame welting application

Thank you Brent.

A friend drove over to my home with his project Model A Ford which the body had not been removed from the frame. After looking at the frame underneath the car, I could see the webbing positioning under the body apron. The webbing was observed not being installed past the body apron on the frame.

The positioning for the Anti-squeak material was the same as pictured in the photo you sent. It appeared the webbing applied to the frame did not go past the body apron. Thanks very much for your input, and additionally thank everyone else who responded to this post.
California Charlie is offline   Reply With Quote