Re: Starting the flathead with Chevy Distributor
I did have a Pentronix Flame Thrower coil with a 1.5 ohm internal resistor(12v by the way). I changed it out for a standard coil for use with external resistor. I wired it up according to the diagram which one wire from +side of coil to I post on voltage regulator then another wire also going from +side of coil to the resistor but that's where i was not sure where the wire went from the other side of the resistor. It looked like it was going to the switch? I will check to see if the plate is grounded. I would not think Bubba would overlook something as important as not grounding the plate.
|