Sponsored Links (Register now to hide all advertisements)
Quote:
Originally Posted by flathead 53
I have the h6006 halogen seal beams in my 53 f-100 ,getting 6 volts to head lights ,good grounds ,not very bright . installed A pair of driving lights on bumper ,also halogen ,very bright , head lights I noticed that high beam indicator is on when you go from high to low , beams don't seam to change, when you hit the floor switch ,wiring is all new also, can head light switch be going bad?
|
BigJob offers some good advice. The hi/lo switch is often the culprit in this circuit in regard to the issue you are experiencing.
Many times by simply pushing that switch in and out rapidly a number of times, it will clean the internal contacts enough to remedy your issue.
Still, test that switch... they're cheap enough if you need to replace it.