Re: Tranny Leak
When installing this washer you have to slide it into the U-joint at the opening in the center to get it up against the rear flange of the forward part of the U-joint. Then you have to come in from the very rear of the U-joint with the bolt and the lock washer in a 3\8" drive 9\16" socket on a long extension. Fish it around until it goes through the notched washer and into the end of the main shaft. The notch should drop into one of the flutes as you tighten it. Don't over tighten the bolt as it will cup the notched washer. It does not hurt to put a little sealer on the front of the notched washer.
Tom Endy
|