Quote:
Originally Posted by john charlton
I had a piece of laminated glass cut with the measurements as per the Service Bulletins . The glass goes up and down OK but when it reaches the top there is an air gap towards the back about 1/2 " . When the glass is halfway up the top edge is more or less level with the bottom door window ledge .It does not show the approx 1" difference in height between the front and back of the glass .Anybody else noticed this ??? .The glass is uniformly seated in the metal lifter . Maybe something is bent somewhere ,thinks .
John in Autumn has arrived Suffolk County England .
|
John, What page of the Service Bulletins are you referring to? There should not be the 1" gap you reference. When the glass is lowered to the bottom, is the rear higher than the front? How much tilt is there in the glass (i.e. when half way up can the glass be tilted to raise the rear)? There should be almost no tilt.