[REByar]

Yes, the dog bone fell out. There is play (side to side) when the dog bone is in the two cup shafts. I have tried to get it back into the "U" and into the two cup shafts and there is not enough room. But if I put the dog bone into the two cup shafts it moves where it barley stays in one or the other cup. I saw Snyders has the dog bone and it has a round end but flat point where mine has balls on either end. I thought of putting small washers in each cup to take up the slack.

What do you think? Also, since the "U" shaft will only accept the dog bone by putting the middle of the bone in and pushing up there is not enough room to put the ends of the bone into the cups. Any ideas to make more room. I need about 1/4 of an inch. Is there a way to pull the "U" shaft up and then put it down when the dog bone is in both cups?

Thanks
Randy