[QUOTE=Kube;820934]
Quote:
Originally Posted by V8COOPMAN
OK Jim, there's my 16" of angle, cut into four fours, drilled with a drill and clamped with four bolts. DD
This appears to be decent method to install reverse eye springs too. What keeps the spreader held safely against that piece of angle iron?
|
Quote:
Originally Posted by Kube
Lonnie,
I set up a spring with spreader on my bench to depict the way I do it. It is a very simple in design as you can see. Works amazingly well and is safe.
In the "real world" I use a heavier shackle pin to press against. The one in the photo was handy for taking the photo.
|
Pretty slick Kubarth, and simple! I'd graciously settle for "runner-up" status with my meager example when compared with yours, below. Folks can learn a little bit more every day (myself included), if they'll pay attention with an open mind. Again......SLICK! DD