The Ford Barn - View Single Post

BillCNC · 02-17-2018, 01:49 PM

Hi hardtimes,

Thanks for the reply. Tweaking the slot's was referencing to slightly modifying the slot's at both ends of the shaft only if needed with a file so the tang's index smoothly with no binding.

Regards
Bill

02-17-2018, 01:49 PM	#3
BillCNC Senior Member Join Date: Aug 2017 Location: SoCal Desert Posts: 826	Re: Distributor Install Question Hi hardtimes, Thanks for the reply. Tweaking the slot's was referencing to slightly modifying the slot's at both ends of the shaft only if needed with a file so the tang's index smoothly with no binding. Regards Bill