Re: Bendix Spring bolts
Recently I have run into two starter dives that had a 5/16” bolt in the spring on the starter end and a 3/8” bolt in the hole in the A-13357 sleeve end of the shaft.
Was this done at the factory or done to attach the new A-11357 starter drive sleeve which only comes with the 3/8” threaded hole?
Snyder sells a package of 2-3/8” bolts or a package of 2-5/16” bolts.
The sleeves did not have the slots milled on each side as called out in Snyder’s catalog.
Last edited by GPierce; 11-09-2023 at 10:11 PM.
|