View Single Post
Old 05-31-2019, 01:32 PM   #7
jhowes
Senior Member
 
Join Date: Jul 2010
Location: upstate NY near Mass border
Posts: 789
Default Re: differential assembly

I found that the bearings were not fully seated on the carrier. The space measured about 30+ thousands behind the bearings. After some persuasion I was able to close that up to less than 10 thousands. Now I have gaskets stacked at 30 thousands and the ring gear is still spinning freely. When I get a little umph, i'll start reducing gaskets until I get the drag that I am looking for. Thanks again for everyone's help. Jack
jhowes is offline   Reply With Quote