The Ford Barn - View Single Post

Bob C · 06-27-2020, 04:02 PM

It is possible the nut is bottomed out on the crank snout, you may
need to add a washer. The ID of the washer need to be a little bigger than the OD of the snout.

06-27-2020, 04:02 PM	#2
Bob C Senior Member Join Date: May 2010 Location: So Cal Posts: 8,754	Re: 29 Tudor crank pulley question It is possible the nut is bottomed out on the crank snout, you may need to add a washer. The ID of the washer need to be a little bigger than the OD of the snout.