View Single Post
Old 10-19-2020, 12:55 PM   #12
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 9,733
Default Re: Time lapse Model A engine build

Quote:
Originally Posted by alexiskai View Post
Is the crankshaft hard enough to serve as an adequate substitute for the OEM roller burnishing?
Yes. The crankshaft was the original burnisher. Even on a rebuild where the crankshaft has been resized, it is an advantage to use the crankshaft to burnish.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote