View Single Post
Old 09-17-2020, 10:32 AM   #14
Bob Bidonde
Senior Member
 
Bob Bidonde's Avatar
 
Join Date: May 2010
Location: Long Island, NY
Posts: 2,050
Default Re: PCV valve good idea?

I modified a reproduction Air Maze by putting a copper fitting into its throat. I also took an accessory draft tube that was on the breather and replaced its metal flex line with a rubber hose. The hose was connected to the Air Maze. No PCV was used. This setup did reduce leakage from the rear main, and it ran really well. I am demanding of my engines to produce power, and I did not notice any degradation in power. The engine had Motorcraft TT10 Spark Plugs and they ran clean.
Attached Images
File Type: jpg DSCN3253.jpg (75.2 KB, 4 views)
__________________
Bob Bidonde
Bob Bidonde is offline   Reply With Quote