Thread: Mixing lifters
View Single Post
Old 09-17-2020, 07:42 AM   #4
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 915
Default Re: Mixing lifters

If you have a couple valves that require adjusting, just grind those valves to the proper clearance. If you go to the trouble of removing the can cam to change out those lifters, change them all. I don't see any reason why you can't run some of each just don't see the point either
Licensed to kill is offline   Reply With Quote