Quote:
Originally Posted by chrs1961815
As someone who rebuilds distributors here, I would stick with the original setup with the shortproof condenser available from most of the suppliers.
.
|
That is the route I would go too. An A&L condensor and the original point setup. The originals are so much easier to set the point gap than the 'modern' type.
I had a modern type setup, it was OK, but I took it off after a couple years and went back to original. I like that better it was a good design.
Welcome masipopa and don't be afraid to ask questions here, 98% of the guys are very helpful and kind. You'll be treated OK