View Single Post
Old 04-21-2015, 03:51 PM   #7
Tom Wesenberg
Senior Member
 
Tom Wesenberg's Avatar
 
Join Date: May 2010
Location: Mpls, MN
Posts: 27,582
Default Re: When replacing a condenser, where does the insulating washer go?

Quote:
Originally Posted by oldbike99 View Post
Is it possible to hold the screw/washer in place while replacing the condenser, or does the distributor need to be disassembled in order to replace the condenser?
Changing the condenser is a very easy one minute job IF you follow these steps:

Lay the new condenser next to the distributor and unscrew the ground screw FIRST.

Walk to the driver's side and unscrew the terminal screw and keep holding light pressure on the screw.

Slip out the old condenser and slip in the new condenser and turn in the terminal screw.

Walk to the passenger side and turn in the ground screw. JOB DONE

Forgot to mention........if you have 6 helpers, the job could take an hour.

Last edited by Tom Wesenberg; 04-21-2015 at 06:46 PM.
Tom Wesenberg is offline   Reply With Quote