Quote:
Originally Posted by krwilson5
Thanks, Scicala, 66 it is. Just like 46Yblock said he found. I noticed though, that the jet in my 1904 has been mistreated. It looks like it was drilled out. the hole is bell shaped and off center. at any rate it is toast. Are these available new? I checked a site that carries just about any hole size for Holleys and they seem to fit just about all the Holleys, but not sure that they fit the old 1904. The thread size quoted was 1/4-32. Anyone know if the newer jets are the same as the old? It's time to get all those carb guts off my bench and back on the car.
|
1/4x32 is correct thread size for holley jets. Their a tapered seat NO gasket is used. ken ct. I may have some .066 if you cant find any.