The Ford Barn - View Single Post - Broken stud removal with a new twist! + Engine stand mods! Machining time at Mart's!

RKS.PA · 01-21-2022, 02:48 PM

Hi, Mart!

Yet another great video!! I was right there with you on the stud removal!! Have found that, and just as you said, your first weld is very important. I've done this by welding on a nut, with lots of weld build up between it and the broken stud in order to keep it from breaking away, but then each "operation" is different on these difficult patients!! Also, set my MIG toward the upper end of the amp range.
Thank you again for posting!!

01-21-2022, 02:48 PM	#5
RKS.PA Senior Member Join Date: Jun 2010 Location: Marana, AZ Posts: 1,194	Re: Broken stud removal with a new twist! + Engine stand mods! Machining time at Mart Hi, Mart! Yet another great video!! I was right there with you on the stud removal!! Have found that, and just as you said, your first weld is very important. I've done this by welding on a nut, with lots of weld build up between it and the broken stud in order to keep it from breaking away, but then each "operation" is different on these difficult patients!! Also, set my MIG toward the upper end of the amp range. Thank you again for posting!!