The Ford Barn - View Single Post

Jim Brierley · 11-10-2020, 12:48 PM

I run a Mallory dual point built for a Datsun, later named Nissan. It takes some minor lathe work to make it fit the head, and a new drive shaft was needed, not a problem.

11-10-2020, 12:48 PM	#4
Jim Brierley Senior Member Join Date: Jun 2010 Location: Temecula, CA Posts: 4,089	Re: Nissan distributor for Model A I run a Mallory dual point built for a Datsun, later named Nissan. It takes some minor lathe work to make it fit the head, and a new drive shaft was needed, not a problem.