The Ford Barn - View Single Post

BoxCar Tom · 01-18-2021, 09:03 PM

Carl,

I don't think a rotisserie for a 32 roadster body is available on the open market, same with plans. I think your on your own. If I were doing it I would buy two engine stands, then install a stock firewall and use the engine snubber mount holes as a rotisserie mount point. The back is a lot more tricky. Assuming you have a floor and sub-rails, I would create a mounting plate in the body and use body to frame mount points and the front corners of the deck lid opening as attachment points. Keep in mind that both rotisseries must be on the same axis.

There is another design that uses hoops attached to the bottom of the body. The hoops surround the body. You roll the body on the hoops.

Good luck.

01-18-2021, 09:03 PM	#2
BoxCar Tom Senior Member Join Date: May 2010 Location: Basking Ridge, NJ Posts: 591	Re: 32 Roadster Carl, I don't think a rotisserie for a 32 roadster body is available on the open market, same with plans. I think your on your own. If I were doing it I would buy two engine stands, then install a stock firewall and use the engine snubber mount holes as a rotisserie mount point. The back is a lot more tricky. Assuming you have a floor and sub-rails, I would create a mounting plate in the body and use body to frame mount points and the front corners of the deck lid opening as attachment points. Keep in mind that both rotisseries must be on the same axis. There is another design that uses hoops attached to the bottom of the body. The hoops surround the body. You roll the body on the hoops. Good luck.