The Ford Barn - View Single Post

scicala · 12-05-2018, 01:38 PM

If the slot in the brass seat is stripped, then even the best correct tool won't work. Why not try an easy-out or stud extractor that fits in the ID of the brass seat.

Also, I worked in the original Detroit Zenith carburetor engineering lab from 1972 to 1984 when they moved to Abingdon, VA. I was issued a tool kit which included this tool, however it's long gone.

Sal

12-05-2018, 01:38 PM	#9
scicala Senior Member Join Date: Jun 2010 Location: Detroit suburb, MI Posts: 3,706	Re: Carburetor Float Valve Seat Wrench If the slot in the brass seat is stripped, then even the best correct tool won't work. Why not try an easy-out or stud extractor that fits in the ID of the brass seat. Also, I worked in the original Detroit Zenith carburetor engineering lab from 1972 to 1984 when they moved to Abingdon, VA. I was issued a tool kit which included this tool, however it's long gone. Sal