Quote:
Originally Posted by 30Tudor
... I just got a new gasket from Synders (see picture) ...
|
Quote:
Originally Posted by fordgarage
...For pan gaskets I use a coating of chassis grease on each side, no sealer...
|
Quote:
Originally Posted by john in illinois
...Follow the directions and torque it as recommended...Lock the pump in with a locking tool available from suppliers cheap or make one from a pipe plug and a bolt. Tool screws into the hole in the block by the oil pump...
|
I pretty much followed the above, held the pan in place with a scissor jack, put 4 bolts in to locate everything. Have a couple hundred miles on it -- so far-so good!