The Ford Barn - View Single Post

Glenn C. · 09-13-2016, 09:28 AM

I have not proven it one way or another yet, but the hole in the ball on the repo shift leavers have been miss drilled, causing the shift leaver to locate to the drivers side too much. A friend of mine had his snap off the other day on a short trip, where the two pieces of the shift leaver are welded together.

09-13-2016, 09:28 AM	#2
Glenn C. Senior Member Join Date: May 2010 Location: Didsbury Alberta Posts: 838	Re: Shift Tower rebuilders I have not proven it one way or another yet, but the hole in the ball on the repo shift leavers have been miss drilled, causing the shift leaver to locate to the drivers side too much. A friend of mine had his snap off the other day on a short trip, where the two pieces of the shift leaver are welded together.