07-18-2016, 01:28 AM
|
#3
|
Senior Member
Join Date: May 2010
Location: South Florida
Posts: 14,054
|
Re: Darkening original engine bolts...
Quote:
Originally Posted by Special Coupe Frank
I searched the Forum earlier today, looking for info about recreating the blackish, "Raven" finish on original engine bolts.
Let me say that I am NOT building a "points car", but would like to come close to correct appearance.
I saw some comments about cleaning the bolts ( de-grease, wire-brush ), heating with a torch, then dunking in used motor-oil.
Can someone suggest a temperature to heat the bolts to if I were to heat the bolts in a pan, say in the oven or gas-grille (don't tell my wife!) ?
It would be a lot more expedient ( and controlled ) to heat a batch of bolts in a controlled manner than for me to do one at time in a flame...
Thanks !
Frank
|
Just before red hot.
__________________
What's right about America is that although we have a mess of problems, we have great capacity - intellect and resources - to do some thing about them. - Henry Ford II
|
|
|