View Single Post
Old 07-25-2020, 03:25 PM   #7
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 882
Default Re: Decided to pull the motor/trans

Quote:
Originally Posted by 100IH View Post
I'll deal with only one item. The ring gear needs the rounded side of the teeth at the rear as it sits in the chassis. When you remove the starter the bendix goes past the ring gear and comes forward to engage, the rounded end of each tooth aids in engaging. same for the bendix, rounded end is the engage side.
Ah yes, I see that now. I never paid much attention. It's "backwards" from what I am used to. I'll change out the gear. Thanks
Licensed to kill is offline   Reply With Quote