View Single Post
Old 07-25-2020, 02:08 PM   #6
100IH
Senior Member
 
Join Date: Dec 2011
Location: SW Idaho
Posts: 958
Default Re: Decided to pull the motor/trans

Sponsored Links (Register now to hide all advertisements)
I'll deal with only one item. The ring gear needs the rounded side of the teeth at the rear as it sits in the chassis. When you remove the starter the bendix goes past the ring gear and comes forward to engage, the rounded end of each tooth aids in engaging. same for the bendix, rounded end is the engage side.
100IH is offline   Reply With Quote