View Single Post
Old 07-25-2020, 01:51 PM   #4
Licensed to kill
Senior Member
 
Licensed to kill's Avatar
 
Join Date: Aug 2016
Location: Alberta
Posts: 880
Default Re: Decided to pull the motor/trans

Quote:
Originally Posted by Patrick L. View Post
Valve guides in any engine will not cause that much oil consumption. Ringing it properly is a good thing. But, with .008" taper I would recommend sending it out for boring. I prefer to leave the piston clearances a bit on the wide/loose side. But, thats just me.
I already removed the taper and brought the cylinders to 4" (the pistons mic 3.998). well, 3 are done, one to go.
Licensed to kill is offline   Reply With Quote