Mart, when we sleeve a block that has a broken-out piece that goes to water (like when an errant rod gets loose) or has cracks like you see there, we use this:
https://www.cylinderheadsupply.com/k...hoCcAsQAvD_BwE
It's the best we've found,and does a good job. Of course stop drilling cracks and possibly pinning the end to reduce the gap of a wide crack is recommended,but we have good results installing sleeves with Fluid Weld.
Terry
__________________
"It don't take but country smarts to solve the problem" (Smokey Yunick)
'41 Merc Town Sedan / 260" 8CM engine
'66 Fairlane four door / "warmed up"
302