View Single Post
Old 10-08-2020, 12:36 AM   #57
Brian
Senior Member
 
Brian's Avatar
 
Join Date: May 2010
Location: Masterton, New Zealand
Posts: 3,816
Default Re: Question on Cam Gear Marks - UPDATE

Russ, you 'know' this cam is right because it's previously run very satisfactorily in an earlier engine. You 'know' where TDC is. BUT, you don't 'know' how the camshaft is timed to the crankshaft. Please, follow flatjacks or my advice. Your original question pertained to timing marks. Whatever 'marks' you have ultimately used, obviously are wrong. Until you have established actual cam timing events, anything else is pure conjecture. I'm not going to post anymore on this thread. I can only offer advice, if you choose not to follow it, so be it. Again, good luck!
__________________
Unfortunately, two half wits don't make a whole wit!

Last edited by Brian; 10-08-2020 at 12:48 AM.
Brian is offline   Reply With Quote