View Single Post
Old 09-15-2020, 01:23 PM   #38
Tony, NY
Senior Member
 
Join Date: May 2010
Location: Capital of Corruption , NY
Posts: 810
Default Re: Crank pulley bolt...Lost again!!

I would also use regular socket screws (drilled). Some info on button head screws: "Button head screws, set screws, and studs cannot be torqued like ordinary screws. These screws have a small contact area where the tool is applied compared to other kinds of head types (e.g. hex, socket, cap, Torx, etc.) Torque on these screws must be reduced. If this is not done, either the screw, the piece being fastened, or the tool will be damaged."
Tony, NY is offline   Reply With Quote