The Ford Barn - View Single Post

Bud · 07-15-2020, 11:33 AM

To my knowledge, the earlier 1930 coupe models had a flange at the lower end of the window that will have to be cut off to install a roll-down rear window assembly. The 1931 models had no flange in this area to allow installation. I may be wrong on this point, but that is what I recall. This flange is not usually mentioned regarding installing these parts.

07-15-2020, 11:33 AM	#10
Bud Senior Member Join Date: May 2010 Location: Ohio Posts: 819	Re: Coupe back roll up window To my knowledge, the earlier 1930 coupe models had a flange at the lower end of the window that will have to be cut off to install a roll-down rear window assembly. The 1931 models had no flange in this area to allow installation. I may be wrong on this point, but that is what I recall. This flange is not usually mentioned regarding installing these parts.