Quote:
Originally Posted by rich b
From the width, I'm thinking it is a roller skate wheel.
Picture's off the net. Was going to make one; but instead used a saw cut in a flat bar to tip the edge.
|
What i have to do is close up a hemmed edge on a 8 ft long edge of 24 gauge so 2 rollers 1" wide will work even if i have to go over it a couple times. A hand held tool is easier then handling the sheet by myself and try and run it through a bench mounted bead roller. Using a air ratchet is my plan. I just remembered seeing the ratchet powered one years ago.