The Ford Barn - View Single Post

Mart · 09-26-2021, 10:12 AM

I've used a couple of early 32 driveshafts to make later V8 32 driveshafts. If you can get a 10 spline to 6 spline adaptor it is easier, but if you only have the 6 spline coupler you need to make up a short adaptor to bring the diameter up. Not a bad job if you have a lathe.

09-26-2021, 10:12 AM	#12
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,755	Re: Building a late 32 driveshaft I've used a couple of early 32 driveshafts to make later V8 32 driveshafts. If you can get a 10 spline to 6 spline adaptor it is easier, but if you only have the 6 spline coupler you need to make up a short adaptor to bring the diameter up. Not a bad job if you have a lathe.