Not sure if I should pirate this string but it lines up with a question I was going to post. So will give it a shot. What size PCV valve do you guys use? Or, how do I know if I am getting enough air flow? I have a 1950 8BA, I used my original draft tube assembly and drilled a hole in the tube and treaded in a hose nipple. Then capped off the original draft tube at the bottom. From the new nipple I ran a rubber hose to catch can then to a PCV then to the manifold. The plumbing all seems to work out. But I don't know if I am getting proper flow through it. I'm not pulling a notable vacuum in the crankcase. I used a heater hose to make a sealed fitting on the dipstick.
Sent from my SM-G973U using Tapatalk