Re: Front engine mount for 292 Y-block
If you want to raise the front of the engine after it's installed you may need to slightly loosen the steady-rest rods on the sides of the block.
My '55 Bird also came with with an incorrect engine block and a front mounting bracket like photo two, I swapped it for the bracket in photo three. They seemed enough the same I didn't compare their height to each other.
I didn't measure the height of the one I took out.
-edit-
The overall height of the T-Bird style front bracket is about 6 inches. From its bottom surface to the center of the upper bolt holes is approx 5 & 1/2 inches, with the one on the passenger side about 1/8 inch higher than the one on the drivers side.
.
Last edited by dmsfrr; 11-30-2020 at 12:08 PM.
Reason: added measurement info
|