The Ford Barn - View Single Post

Bob-A · 01-13-2014, 06:51 PM

Holy-Moly!!.....

I just wanted to know which way is best to set up an
"A" intake for a "B" carb. I was a Water PLant Operator for 30 years and
when H. L. Chauvin mentioned "pipe diameter.....length & surface friction..." I thought I had a flash-back.....

Thanks everybody for your learned input. The experience & knowledge
you guys have is invaluable to me and I'm sure other people of the board. I truely enjoy reading everybodies piece of wisdom and can not wait for the next one. Thanks again.

Bob-A

PS: Dave in MN has a good example of how and what to do on his
website. I think that is the direction I'll go.

01-13-2014, 06:51 PM	#15
Bob-A Senior Member Join Date: May 2010 Location: Central FL, USA Posts: 1,137	Re: Boring A intake for B carb.... Holy-Moly!!..... I just wanted to know which way is best to set up an "A" intake for a "B" carb. I was a Water PLant Operator for 30 years and when H. L. Chauvin mentioned "pipe diameter.....length & surface friction..." I thought I had a *flash-back*..... Thanks everybody for your learned input. The experience & knowledge you guys have is invaluable to me and I'm sure other people of the board. I truely enjoy reading everybodies piece of wisdom and can not wait for the next one. Thanks again. Bob-A PS: Dave in MN has a good example of how and what to do on his website. I think that is the direction I'll go.