Re: Mysterious hole in valve chamber?
Hello everybody,
I thought again. (Last night, the whole day ...) I can not believe that the breakthrough was "just hit somewhere" inside. Because then the correct height of the overflow for the oil pipe is at the wrong (too low) level.
I measured it.
1) The lowest overflow edge from the return opening in the valve cover.
2) The lower edge of the breakthrough. I have marked marks outside. (see picture)
It can be clearly seen that the lower edge of the break hole is about 1/4 inch below the discharge edge of the return pipe.
Then the return pipe would make no sense, because the oil level does not reach the return opening.
__________________
Beste Gruesse aus Deutschland,
Werner
Ford Model A, Roadster, 1928
Citroen 11 CV, 1947
Hercules W 2000, 1976; (with NSU-Wankel Rotary Engine), Canadian version
|