View Single Post
Old 09-16-2020, 09:48 AM   #8
big job
Senior Member
 
big job's Avatar
 
Join Date: Sep 2013
Location: Dighton, Mass
Posts: 1,225
Default Re: installing engine

If you do not have a clutch disk mandrel you can easily take the input shaft out of the
transmission for a alignment tool that has to be precision. Then with out the turning of
the crankshaft pulley nut just put in gear jack up one rear wheel with a helper rock
rear wheel until splines mesh, on closed drive shaft) open drive shaft jack up and turn
shaft until it slides right in ......block and trans must be parallel like Ronnie said with studs
or cut off bolts
big job is offline   Reply With Quote