Quote:
Originally Posted by txmike
ok guys - back from vacation. New Coil and new coil wire came in
I have checked all connections, all have voltage. Checked with a light and ohm meter
i get power to lower and upper plate - but the problem is it does not appear to be going to the points (Open or closed)
This is a new set of points etc; modern version with condenser up top, from NuRex
so what could the problem be. The lower plate looks fine, no corrosion etc
|
When checking for voltage at the points, be sure to insert a non-conductive material (a thin piece of cardboard) between the points. Then voltage will be read on the movable arm, but not on the fixed point side.
Do you have a wire between lower plate and points on upper plate?