The Ford Barn - View Single Post

Mart · 09-13-2020, 12:23 PM

A steel bolt in a steel nut of suitable grade of steel will achieve the numbers quoted above, but as it is being screwed into a cast iron crank snout would a lower value be more appropriate? I am thinking 50 lbs sounds a bit low, though.

Mart.

09-13-2020, 12:23 PM	#19
Mart Senior Member Join Date: May 2010 Location: Solihull, England. Posts: 8,750	Re: Crank pulley bolt...Lost again!! A steel bolt in a steel nut of suitable grade of steel will achieve the numbers quoted above, but as it is being screwed into a cast iron crank snout would a lower value be more appropriate? I am thinking 50 lbs sounds a bit low, though. Mart.