Thread: Seafoam
View Single Post
Old 05-01-2021, 12:24 PM   #5
BRENT in 10-uh-C
Senior Member
 
BRENT in 10-uh-C's Avatar
 
Join Date: May 2010
Location: Eastern Tennessee
Posts: 11,519
Default Re: Seafoam

Jim, the basic answer is yes. Ideally you can use a plastic straw on the end of an aerosol can of carburetor cleaner to start the initial dissolving of the dried gasoline. I am assuming you are using an electric pump, but however you can mix some Seafoam in about a 50/50 mixture and get it into the carb. bowl, it will likely start working on the accelerator pump circuit too.

Once you have it cleaned, find a small municipal airport where you can purchase some 100LL fuel for your boat in a jug, and then install that into your truck's fuel tank away from the airport. The AV gas does not sour or taint like ethanol fuels do, so this should keep the passageways open during stowage. Around here, we are paying about $5.30 a gallon for the AV gas, but it is a much better solution IMO.
__________________
.

BRENT in 10-uh-C
.
www.model-a-ford.com
...(...Finally Updated!! )

.
BRENT in 10-uh-C is offline   Reply With Quote