View Single Post
Old 11-11-2012, 06:26 PM   #10
1oldtimer
Senior Member
 
1oldtimer's Avatar
 
Join Date: May 2010
Location: South Orange County, Ca.
Posts: 680
Default Re: Has anyone used the HOT ROD WORKS open driveline conversion kit?

Lots of stuff on the HAMB about HRW pieces and converting your '40 to open drive. I'm using '35 bells, '37-'41 axles and the center from a '46 truck and it's going in a '28 Tudor. Not to get too hot rod for the barn, but I'll find some links.

Just a few I have bookmarked.

Rear radius rod posts:
http://www.jalopyjournal.com/forum/s...d.php?t=589044

http://www.jalopyjournal.com/forum/s...d.php?t=533765



DIY Open drive conversion:
http://www.jalopyjournal.com/forum/s...d.php?t=519343

http://www.jalopyjournal.com/forum/s...d.php?t=324073

Last edited by 1oldtimer; 11-11-2012 at 06:39 PM.
1oldtimer is offline   Reply With Quote