The Ford Barn - View Single Post

Pete · 06-14-2014, 03:03 PM

For those of you that were waiting for me to get the "salvage worn journal model A cams" project going, it is going and works good.
The lobe regrind part will be a grind that is very similar to the stock original grind EXCEPT that it will be modern design and run on one inch lifters. It will also have a larger nose radius so it doesn't wear off like the original grind.
I will have a sample of the journal repair for viewing at my shop during the Puyallup meet time. I am 45 minutes by model A from the fair grounds on the road to Mt. Rainier.

06-14-2014, 03:03 PM	#1
Pete Senior Member Join Date: May 2010 Location: Wa. Posts: 5,417	Cam repair For those of you that were waiting for me to get the "salvage worn journal model A cams" project going, it is going and works good. The lobe regrind part will be a grind that is very similar to the stock original grind EXCEPT that it will be modern design and run on one inch lifters. It will also have a larger nose radius so it doesn't wear off like the original grind. I will have a sample of the journal repair for viewing at my shop during the Puyallup meet time. I am 45 minutes by model A from the fair grounds on the road to Mt. Rainier.